Application Instructions

Heat Press

350 degrees

15-20 seconds

15 P.S.I.

Iron

Preferably an iron with no steam holes.  If your iron has steam holes, you will lose some surface contact.

Wool Setting

NO STEAM!

Step 1: Lay garment on flat surface. Do not use a padded ironing board. For thin garments place a pressing cloth or a piece of flat cardboard inside of garment.

Step2: Remove backing and make sure that all stones are in place and none of the stones have shifted during shipment. If stones have shifted, use tweezers to re-position the stones into the correct place.

Step 3: Place sticky side of paper onto garment and adjust to correct position. Cover the transfer paper with a pressing cloth or Teflon Sheet.

Step 4: Apply heat by lowering iron straight down onto transfer area and push hard for 25-30 seconds. Make sure to cover entire transfer area. DO NOT MOVE IRON AROUND!  The rhinestones will shift if iron is moved around.  Heavier fabrics such as denim might need more time and light fabrics less time. If you are using a heat press do not over do the pressure or you will leave pressure marks on garment. Press for 15-20 seconds.

Step 5: Allow garment to cool until warm, approximately 30 seconds to 1 minute and then slowly remove sticky paper. If your stones are not sticking to your garment, place sticky transfer paper back down and re-apply heat to stones.

Step 6: Test stones by gently picking at them. They should be well attached. Do not try to pull them off too much.

Washing Instructions:

WASH INSIDE OUT, COLD WATER. LOW HEAT OR LINE DRY.

Blingin It takes NO responsibility for damage to garments during this process.